This is an application for configuring the ECU in BeamNG. It works on almost any car, with any engine or turbine. It is built on the principle of a real chip tuning stand, but the main goal is training.

The settings are based on real tables. Color-coded tables of fuel, ignition, boost, and lambdas are available. You can select groups of cells and change them by adding, subtracting, scaling as a percentage, filling, smoothing, interpolating, copying, and pasting. The base and difference map display modes are available, the active cell shows the current position of the engine on the map, as well as a three-dimensional representation of the table.

The real-time page displays all engine operation parameters: lambda, detonation, nozzle bore, fuel pressure, intake temperature and engine status, with alarms in case of deviations.

The built-in dynamometer stand allows you to evaluate the tuning results. After completing the measurement, you get the power and torque curves, and the first measurement is saved as a base for comparison with subsequent ones.

The "Learning / Lessons" button launches the step-by-step guide. The car is set up for the lesson, and the sequence of actions is shown with an explanation of each step.
There are 8 lessons available from beginner to advanced level:
- Reading of instrument indicators
- Correction of the rich fuel mixture
- Power and detonation
- Power setting on the dinostand
- Additional ways to increase power (mixture composition, valve timing, boost)
- Setting up a two-stage limiter for starting
- Boost adjustment on a turbocharged car
- Creating a secure setup with a turbine