DR1A passenger diesel train for Beamng Drive. The mod comes with a wagon. To install, simply drag and drop the downloaded mod into the Mods folder.

- If you have problems with braking, you should drive in realistic mode (press Q) and brake in N gear, I still haven't figured out how to fix this problem, but at least this way you can play

- 12 configurations, 6 liveries. The first 6 configurations have the prefix "Front Engine" at the beginning, these are the main DR1A trains and they should be placed at the beginning of the train, the remaining configurations with the prefix "Rear Engine" are the rear trains and are placed at the end of the train, their only difference is that they have different couplings.
- Fully working headlights, you can switch the front lights and main spotlight separately;
- Moving wheels;
- Correctly placed exhaust;
- Drives well;
- The carriage has seats with a collision, you can walk around the carriage in walking mode.

- To assemble a train, select DR1A with the prefix Front Engine and place it at the beginning of the train, then create carriages. You can create one car and place it on the rails using the editor on F11. When you place the first car on the rails, you can duplicate it by holding Shift and dragging the car in the direction you want, then create DR1A with the prefix Rear Engine. Switch to the first train and press L, make sure that the cars are not stuck in the rails by slightly lifting them up. Then switch to the first coupled wagon, open the radial menu, then click Trailers > "Hook all". If the rear diesel train cannot be coupled, then drive closer to the carriage, release the brakes and switch back to the last coupled carriage and click "Connect all"

(the lighting control is different from my other mods.)
DR1A control:
T — overclocking and press W
G — slow down and press S
L near the speedometer — driving straight ahead
H near the speedometer — moving backwards
Alt + A — change direction
H — beep
K — turning on the front lights
I — turning on the main projector
[ — turning on the right taillight
] — turning on three taillights
Y — interior lighting

DR1A carriage control:
Y — interior lighting

If the train is not moving, make sure it is not stuck in the rails, press f11 and lift it up slightly, if the train is still not moving, release the air brakes (down arrow) and the independent brakes (P/space bar) and switch to m1.

Known problems: poor quality of the driver's cabin, non-opening doors, interior lighting must be turned on separately in each car, interior lighting passes through the floor and illuminates the rails below, the DR1A engine does not have a seat collision, the mod is quite demanding on performance, expect lags if you connect too many cars.
In the future, I plan to replace the cabin with a better one, improve the sounds and improve the livery of the Latvian and Lithuanian Railways.